Often you won’t have parallel surfaces to clamp like this, in those cases the part can be wrapped with surgical tubing.Īll surfaces are now cleaned to ensure the final product looks right. Stud Gun Dent Puller Kit with Complete Accessories, Dent Welder Repair for Auto. In this case it is a few layers of built up tape. Use To Repair Chips And Cracks From All Types Of Laminated Windshield. I like to protect the stock from the clamp with the use of some sort of pad. I inject the epoxy into the crack to ensure coverage of the entire split.Ī small clamp is used to hold the newly glued stock together. I’ve found using a razor blade to scoop up the epoxy works well. To force the epoxy into the crack I am using a disposable syringe. I use Acraglas brown tint from Brownells, it simply mixes in with the epoxy. To help hide the repair, the epoxy should be tinted. I’ll typically use a couple different epoxies on wood stocks Acraglas, Acraglas gel or West Systems. This allows access to the space between the split. In this case, I inserted a screwdriver that was slightly larger in diameter than the hole in the stock. I inspect the crack carefully before deciding a final course of action. In this case, we are going to repair the split with just the epoxy. Depending on the problem you are trying to correct, the addition of small diameter brass pins can be used to strengthen an area. Specialized epoxies are usually the best choice. This isn’t an approach I’d recommend, while some of these repairs will hold, they could fail under use. Sometimes people try to repair these splits with a little wood glue and a finish nail. Note that the crack passes through the centerline of the wrist and the hole that is used to secure the stock to the shotgun via a long screw. It came into the shop on an older semiautomatic shotgun. The old standby is to wrap a dollar bill around the barrel with the ends pointing up. and its authors, do not assume any responsibility, directly or indirectly for the safety of the readers attempting to follow any instructions or perform any of the tasks shown, or the use or misuse of any information contained herein, on this website.įor this project, I ordered the following items from Brownells: If the barrel is freefloated, confirm it has adequate clearance and is not contacting the stock. The contents of are produced for informational purposes only and should be performed by competent gunsmiths only. In this post, we’ll look at a shotgun stock that has a split traveling down its wrist.īefore we begin, let’s take a look at the disclaimer: While it may be possible to purchase a replacement stock, it will likely cost more money than simply repairing the stock you have. (r.) A quick drop of Loctite will keep screws in their place. Sometimes these stocks are victims of improper repairs, other times, they’ve lingered away, forgotten about for years. Use a torque wrench to ensure the scope doesn’t move in the mount and the mount doesn’t move on the rifle. All too often we’ll encounter wood rifle and shotgun stocks that have split due to use, misuse, or improper storage.
0 Comments
Leave a Reply. |